Where are the fuses in a 2003 Jeep Liberty?

Where are the fuses in a 2003 Jeep Liberty?

Fuse box location The fuse panel is on the left side of the instrument panel behind the cover. A label is attached to the fuse panel cover to identify each fuse for ease of replacement.

Where is the fuse panel on a 2004 Jeep Liberty?

The fuse panel is on the left side of the instrument panel.

Why does my car have 2 fuse boxes?

Most vehicles are equipped with two fuse boxes. One is located in the engine compartment and is used to protect engine components such as the cooling system, anti-lock brake pump, and the engine control unit. The fuse box houses a variety of fuses and relays in one convenient place, protected from outside elements.

Do all cars have 2 fuse boxes?

Most cars have two fuse panels. The one in the engine compartment holds the fuses for devices like the cooling fans, the anti-lock brake pump and the engine control unit — all of which are located in the engine compartment.

Can I use a higher amp fuse in my car?

Do not replace a blown fuse with one that has a higher amperage rating. The fuse has a specific amperage rating because it is intended to be the weak link in the circuit to protect the electrical components. It is recommended to bring your vehicle to someone who specializes in auto electrical problems.

What happens if I use a lower amp fuse?

Do not use a fuse with a lower rating– don’t put a 20 amp fues in a 30 amp circuit–because it probably will blow prematurely. Conversely replacing a 20-amp fuse with one rated at 30 amps is dangerous because it may not blow soon enough and damage an electrical component or start a wiring fire.

Can I replace a 5amp fuse with a 3 amp?

A 3A fuse is supposed to break the circuit for any current higher than 3 Amps. So replacing the fuse by a 5 A wire will allow more current than the rated value through the system and might damage appliances or trigger a higher protection scheme to act promoting larger blackout.

Can I replace a 10amp fuse with a 3 amp?

3 amp should be fine. the fuse is mainly there to protect from burning wires. you might try Radio Shack – they would have the fuse in a higher voltage rating (usually 250 volt), but that won’t cause a problem.

Can you run an amp without a fuse?

If you can’t and there is no way that wire can short on anything, then you could get away without it if the amp has fuses….but it should be fused on battery.